Troubleshooting
Entering DDC Data
winDDCU Pop-up Menus
Pop-up Menus
EDID Writer
EDID Multi-Writer
WinISP
EEPROM Writer
IR Transmitter
System Upgrade
EDID Writer Menus
Selects an input port
Loads a
*.ddc file
4-18
This option writes and verifies an EDID data (*.ddc) file on the monitor via a PC.
It is mainly used to enter a single EDID data (*.ddc) file.
This option is used to enter details of multiple (up to 6) EDID data (*.ddc) files at the same time.
This option is used to perform a MICOM upgrade.
This option is used to perform an EEPROM upgrade.
This option creates all the IR data on the PC and transmits the data to the monitor using the
device MTI-2510.
This option is used to upgrade or downgrade the system version using a System Hex file.
Starts
writing
verification
Instructions
To change the mode, press Ctrl + Q
(Selection Factory Write)
Starts