The Back Panel; Figure 3-2: Back Panel - Linksys RV0041 User Manual

10/100/1000 4-Port VPN Router
1-4 (Gigabit) Green. The Gigabit LEDs serve two purposes. If an LED is continuously lit, the Router is
connected to a device through the corresponding port (1, 2, 3, or 4). If the LED is
flashing, the Router is actively sending or receiving data over that port.
10/100 Green. The 10/100 LED lights up when the Router is connected to your cable or DSL
modem.
SFP Green. The SFP (Small Fiber Pluggable) LED lights up when connected to a 10/100
network.
Reset Button The Reset button can be used in one of two ways:
If the Router is having problems connecting to the Internet, press the Reset button for
just a second with a paper clip or a pencil tip. This is similar to pressing the Reset
button on your PC to reboot it.
If you are experiencing extreme problems with the Router and have tried all other
troubleshooting measures, press and hold in the Reset button for 30 seconds. This will
restore the factory defaults and clear all of the Router's settings, such as port
forwarding or a new password.

The Back Panel

The Router's Power port is located on the back panel of the Router.
Power The Power port is where you connect the AC power cord.
Proceed to "Chapter 4: Connecting the Router."
Chapter 3: Getting to Know the Router
The Back Panel

Figure 3-2: Back Panel

Boot: to start a device and cause it to
start executing instructions
9