Linksys BEFVP41 User Manual page 12

Static IP
If your ISP says that you are
connecting through a static or
fixed IP address from your ISP,
perform these steps:
A. Select Static IP as the
WAN Connection Type.
(Shown in Figure 5-6.)
B. Enter the IP Address.
C. Enter the Subnet Mask.
D. Enter the Gateway Address.
E. Enter the DNS in the 1, 2, and/or 3 fields. You need to enter at least one
DNS address.
F. Click the Apply and Continue buttons to save the settings, or click the Cancel
button to clear the settings and start over. When you are finished, then proceed
to step 5.
PPPoE
If your DSL provider says that you are connecting through PPPoE or if you nor-
mally enter a user name
and password to access the
Internet, perform these
steps:
A. Select PPPoE as the
WAN Connection Type.
(Shown in Figure 5-7.)
B. Enter the User Name.
C. Enter the Password.
16
Instant Broadband Series
®
Figure 5-6
Figure 5-7
EtherFast Cable/DSL VPN Router with 4-Port 10/100 Switch
®
D. Click the Apply and Continue buttons to save the settings, or click the Cancel
button to clear the settings and start over.
E. When you are finished, click the Status tab, and then click the Connect
button to start the connection. Proceed to step 5.
RAS
RAS is a service used in
Singapore only. (Shown in
Figure 5-8.) If you are using
a RAS connection, check
with your ISP for the neces-
sary setup information.
When you are finished with
the Setup tab, proceed to
step 5.
PPTP
PPTP is a service used in Europe
only. (Shown in Figure 5-9.) If you
are using a PPTP connection,
check with your ISP for the neces-
sary setup information.
When you are finished with the
Setup tab, proceed to step 5.
Figure 5-8
Figure 5-8
17