Yamaha P-60 Service Manual page 9

speaker can then be removed. (Fig.6)
* After reinstalling the speaker grille assembly, twist
the sections indicated by arrows to prevent it from
being removed easily. (Fig.8)
* When removing the speakers, the speaker cushions
are removed together with them.
Make sure to install the speaker cushions when
reinstalling the speakers.
7. Keyboard Asssembly (Time required: about
7 min)
7-1 Remove the upper case assembly. (See procedure 1.)
7-2 Remove the screw marked [150c] and the screw
marked [160a] to remove the DM holder assembly.
(Fig.3)
7-3 Remove the nine (9) screws marked [190] and the
two (2) screws marked [160b]. (Fig.3)
7-4 Slide the keyboard assembly backward, hold the
central area of it and raise it upright to remove.
(Fig.9)
* It may twist and damage the frame to hold both
side ends of keyboard assembly or to carry it in a
horizantal state.
8. Disassembling the GHD Keyboard
* After inserting a round stick (Rod: TX000670)
between the frame and keys, remove the circuit
boards. (Fig.12)
8-1 Remove the keyboard assembly. (See Procedure 7)
(Fig. 8)
GH-D SW H
[260b]
(Fig. 10)
[260]: Bind Head Tapping Screw-P 3.0X10 MFZN2 (VT413400)
Keyboard Assembly
(Fig. 9)
8-2 GH-D_SW L circuit board.
Remove the seven (7) screws marked [260a]. The
GH-D_SW L circuit board can then be removed.
(Fig.10)
8-3 GH-D_SW H circuit board.
Remove the ten (10) screws marked [260b]. The
GH-D_SW H circuit board can then be removed.
(Fig.10)
GH-D SW L
[260b]
[260a]
P-60/P-60S
Keyboard Assembly
9