Yamaha P-60 Service Manual page 10

P-60/P-60S
* Keys can be removed without removing the circuit
boards.
8-4 White Key
Insert a thin plate between the white keys, near the
triangle mark around the fulcrum of the key, and
press down the stopper marked [A] to remove the
key. (Fig.11, 12)
* Take care not to damage the key spring when
removing a key.
* A black key can be removed after both adjacent
white keys have been removed.
8-5 Hammer, White Key
After a key has been removed, push the key spring
down once to take it out of the hook. (Fig.13)
Place the GH keyboard assembly upside down and
peel away the stopper L88W. The hammer of the
white key can then be removed. (Fig.14)
* The hammer of a black key can be removed in the
same manner.
8-6 Rubber Contact
Remove the GH-D_SW L (or H) circuit board to
remove the corresponding rubber contact. (photo1, 2)
10
GH-D SW H
(photo 1)
Thin metal plate etc.
(Fig. 11)
White key
Rod: TX000670
(Fig. 12)
Key Spring
(Fig. 13)
Hammer, White key
Stopper L88W
(Fig. 14)
Rubber Contact Rubber Contact
(photo 2)
Triangle mark
Spring
Hook