Panasonic NR-CW530H Operating Instructions Manual page 51

Troubleshooting
The inside is
smelling.
The surfaces of
the refrigerator is
hot.
The normal
sounds of
refrigerator.
The
refrigerator
does not
make ice.
The ice does
not form any
ice cube
Unusual
shape of ice
cubes.
●Do you store food with dry odor without wrapping it?
●Because the refrigerator is equipped with the dew prevention
and heat radiation tubes, the surfaces of the refrigerator get
warmer when operating.
●The back and side plates may get warmer especially when
starting up or if the door is frequently opened and closed.
●When the refrigerator starts operation, the sound like water flowing
and boiling water is created. This is the sound of the cooling liquid.
●The noise is generated when the automatic defrost system operated.
●The dilatation of the details inside the refrigerator in the
cooling process can cause sound "crack-crack".
●You may feel that the operation sound is larger because
the compressor operates in high-speed under the following
conditions: the refrigerator does not cool fully on the occasion
such as using it for the first time, opening/closing the door too
frequently, the surrounding temperature is high. The sound
becomes more quiet after cooling fully.
●Check the installation of Water Connection System is
corrected and the water supply tab is opened.
●The ice making process begins after the inside of the
refrigerator is cold enough. (It may take more than 24 hours to
start the process)
●Check if the Auto Ice Off mode is set. (Page 32)
●Do not leave food in the ice maker.
●Do not install or remove the Ice tray frequently.
●If water spills on the Ice box, clean it up.
●Please contact Panasonic Service Center.
●Is the temperature of Freezer room set to a higher temperature
than -20 °C?
→ Adjust to a lower temperature. (Page 25)
●There are protrusions. → The grooves of the Ice tray may be frozen.
●The ice cubes are round or connected to other ice cubes.
→ Ice has been stored for a long time. (Ice cubes get round of
connected by sublimation.)
●The amount of water supplied for Auto Ice making is guaranteed
based on the water pressure measured from the Flow Sensor.
However, when the water pressure is too low (less than
172 kPa (25 psi) as Water Connection System Warning in
Page 4), the size of ice cubes may be smaller than usual.
This is a normal phenomenon.
51