Table of Contents
Advertisement
※ After Water Connection System installation
● Check all connections carefully to prevent leaks.
● Switch on your refrigerator after finishing Water Connection installation.
● Allow at least 4 hours in continuous running for the refrigerator to cool down, in the
condition of no loads inside and the doors are not opened.
● For the first time using Auto Ice making, please check the operation of Auto Ice Off
mode (Page 32).
If Auto Ice Off mode is in operation, turn off this mode.
Activate Auto Ice Clean mode as the instruction in Page 32 to ensure cleaning dust and
eliminate unpleasant smell.
● The first time you use your Water Dispenser, there will be a 1 - 2 minute delay while the
tank fills. Please dispense continuously in about 30 seconds each time.
Run through and discard the first approximately 3 liters (3 qt) of water, stopping
intermittently to remove trapped air in the system.
Failure to do this will result in excessive dripping from your dispenser.
● If the Step 6 flushing the Water Filter of trapped air (Page 15) was skipped, please
follow these below steps in the first time using Water Dispenser to avoid water dripping:
1 Press the Water Dispenser to dispense 4 liters (4 qt) of water.
2 Wait for 3 ~ 5 minutes before dispensing again.
3 Dispense 4 liters (4 qt) of water then wait another 3 ~ 5 minutes.
4 Dispense another 4 liters (4 qt) of water. Your Water Dispenser is ready to use.
● Please note that after a few days once installation is completed, a few drops may appear
from the dispenser as the remaining trapped air is cleared.
● Water Dispenser is set for water to flow out in about 1 second delay to prevent water
from flowing out when accidentally touching the lever of Water Dispenser.
17
Hide quick links:
Advertisement
Table of Contents
