Electronic Emission Notices - Lexmark Z52 User Manual

Limitation of Liability
Your sole remedy under this
Statement of Limited Warranty is set
forth in this section. For any claim
concerning performance or
nonperformance of Lexmark or a
Remarketer for this product under
this Statement of Limited Warranty,
you may recover actual damages up
to the limit set forth in the following
paragraph.
Lexmark's liability for actual
damages from any cause
whatsoever will be limited to the
greater of 1) $5,000 or 2) the
amount you paid for the product
that caused the damages. This
limitation of liability will not apply to
claims by you for bodily injury or
damage to real property or tangible
personal property for which Lexmark
is legally liable. In no event will
Lexmark be liable for any lost profits,
lost savings, incidental damage, or
other economic consequential
damages. This is true even if you
advise Lexmark or a Remarketer of
the possibility of such damages.
Lexmark is not liable for any claim by
you based on a third party claim.
This limitation of remedies also
applies to any developer of materials
supplied to Lexmark. Lexmark's and
the developer's limitations of
remedies are not cumulative. Such
developer is an intended beneficiary
of this limitation.
Additional Rights
Some states do not allow limitations
on how long an implied warranty
lasts, or do not allow the exclusion
or limitation of incidental or
consequential damages. If such laws
•
•
•
38
•
•
apply, the limitations or exclusions
contained in this statement may not
apply to you.
This warranty gives you specific legal
rights. You may also have other
rights which vary from state to state.
Electronic emission
notices
Federal Communications
Commission (FCC)
Compliance Information
Statement
The Lexmark Z52 Color Jetprinter
has been tested and found to
comply with the limits for a Class B
digital device, pursuant to Part 15 of
the FCC Rules. Operation is subject
to the following two conditions: (1)
this device may not cause harmful
interference, and (2) this device
must accept any interference
received, including interference that
may cause undesired operation.
The FCC Class B limits are designed
to provide reasonable protection
against harmful interference in a
residential installation. This
equipment generates, uses and can
radiate radio frequency energy and,
if not installed and used in
accordance with the instructions,
may cause harmful interference to
radio communications. However,
there is no guarantee that
interference will not occur in a
particular installation. If this
equipment does cause harmful
interference to radio or television
reception, which can be determined
by turning the equipment off and on,
the user is encouraged to try to
correct the interference by one or
more of the following measures:
• Reorient or relocate the receiving
antenna.
• Increase the separation between
the equipment and receiver.
• Connect the equipment into an
outlet on a circuit different from
that to which the receiver is
connected.
• Consult your point of purchase or
service representative for
additional suggestions.
The manufacturer is not responsible
for any radio or television
interference caused by using other
than recommended cables or by
unauthorized changes or
modifications to this equipment.
Unauthorized changes or
modifications could void the user's
authority to operate this equipment.
Note:
To assure compliance
with FCC regulations on
electromagnetic interference for a
Class B computing device, use a
properly shielded and grounded
cable such as Lexmark part
number 1329605 for parallel
attach or 43H5856 for USB attach.
Use of a substitute cable not
properly shielded and grounded
may result in a violation of FCC
regulations.
Any questions regarding this
compliance information statement
should be directed to:
Director of Lab Operations
Lexmark International, Inc.
740 West New Circle Road
Lexington, KY 40550
(606) 232-3000