Electronic Emission Notices - Lexmark Z53 Color Jetprinter User Manual

Steps to basic printing
Beyond the basics
Maintaining your printer
Troubleshooting
Appendix
Index
In this section, you can find
information about:
• Notices
• Safety information
Electronic Emission
Notices
Federal Communications
Commission (FCC)
Compliance Information
Statement
The Lexmark Z53 Color Jetprinter
has been tested and found to
comply with the limits for a Class B
digital device, pursuant to Part 15
of the FCC Rules. Operation is
subject to the following two
conditions: (1) this device may not
cause harmful interference, and (2)
this device must accept any
interference received, including
interference that may cause
undesired operation.
The FCC Class B limits are
designed to provide reasonable
protection against harmful
interference in a residential
installation. This equipment
generates, uses and can radiate
radio frequency energy and, if not
installed and used in accordance
with the instructions, may cause
harmful interference to radio
communications. However, there is
no guarantee that interference will
not occur in a particular
installation. If this equipment does
cause harmful interference to radio
or television reception, which can
be determined by turning the
equipment off and on, the user is
encouraged to try to correct the
interference by one or more of the
following measures:
• Reorient or relocate the
receiving antenna.
• Increase the separation
between the equipment and
receiver.
• Connect the equipment into an
outlet on a circuit different from
that to which the receiver is
connected.
50
Appendix
• Consult your point of purchase
or service representative for
additional suggestions.
The manufacturer is not
responsible for any radio or
television interference caused by
using other than recommended
cables or by unauthorized changes
or modifications to this equipment.
Unauthorized changes or
modifications could void the user's
authority to operate this
equipment.
Note: To assure compliance with
FCC regulations on
electromagnetic interference for
a Class B computing device, use
a properly shielded and
grounded cable such as Lexmark
part number 1329605 for parallel
attach or 43H5856 for USB
attach. Use of a substitute cable
not properly shielded and
grounded may result in a
violation of FCC regulations.
Any questions regarding this
compliance information statement
should be directed to: