Summary of Contents for Seagate BARRACUDA ST1000DM014
Page 1
SATA Product Manual Standard models ST2000DM008 ST1000DM014 100817550, Rev. M September 2022...
Page 2
Seagate, Seagate Technology and the Spiral logo are registered trademarks of Seagate Technology LLC in the United States and/or other countries. SeaTools is either trademarks or registered trademarks of Seagate Technology LLC or one of its affiliated companies in the United States and/or other countries. All other trademarks or registered trademarks are the property of their respective owners.
For information regarding online support and services, visit: www.seagate.com/contacts/ For information regarding Warranty Support, visit: www.seagate.com/support/warranty-and-replacements/ For information regarding data recovery services, visit: www.seagate.com/services-software/recover/ For Seagate OEM and Distribution partner and Seagate reseller portal, visit: www.seagate.com/partners Seagate BarraCuda Product Manual, Rev. M...
SATA ports are represented to host software as a Device 0 (master) and Device 1 Note (slave) accessed at the same set of host bus addresses. A host adapter that emulates a master/slave environment manages two sets of shadow registers. This is not a typical SATA environment. Seagate BarraCuda Product Manual, Rev. M...
Operating temperature (drive case max °C) 60° 20°C per hour max (operating) Temperature gradient 30°C per hour max (non-operating) 5% to 90% (operating) Relative humidity 5% to 95% (non-operating) Relative humidity gradient (max) 30% per hour Seagate BarraCuda Product Manual, Rev. M...
Page 9
† Seagate does not recommend operating at sustained case temperatures above 60°C. Operating at higher temperatures will reduce useful life of the product. If the drive is powered-off before issuing flush cache command, in some instances, Note the end user data in the DRAM cache might not be committed to the disk.
• Using 5-volt power, the drive is expected to operate with a maximum of 150 mV peak-to-peak sine-wave injected noise at up to 10MHz. Equivalent resistance is calculated by dividing the nominal voltage by the typical RMS read/write current. Note Seagate BarraCuda Product Manual, Rev. M...
If the standby timer reaches zero before any drive activity is required, the drive makes a transition to Standby mode. In both Idle and Standby mode, the drive accepts all com- mands and returns to Active mode when disk access is necessary. Seagate BarraCuda Product Manual, Rev. M...
† Operating (Drive case max °C) 60° (140°F) † Seagate does not recommend operating at sustained case temperatures above 60°C. Operating at higher temperatures will reduce useful life of the product. HDA Temp. Check Point Figure 1 Location of the HDA temperature check point...
2.8 bels (typical) 3.1 bels (typical) 2.9 bels (max) 3.3 bels (max) *During periods of drive idle, some offline activity may occur according to the S.M.A.R.T. specification, which may increase acoustic and power to operational levels. Seagate BarraCuda Product Manual, Rev. M...
2.9.1 Test for Prominent Discrete Tones (PDTs) Seagate follows the ECMA-74 standards for measurement and identification of PDTs. An exception to this process is the use of the absolute threshold of hearing. Seagate uses this threshold curve (originated in ISO 389-7) to discern tone audibility and to compensate for the inaudible components of sound prior to computation of tone ratios according to Annex D of the ECMA-74 standards.
The silver, copper, nickel and gold films used in Seagate products are especially sensitive to the presence of sulfide, chloride, and nitrate contaminants. Sulfur is found to be the most damaging. In addition, electronic components should never be exposed to condensing water on the surface of the printed circuit board assembly (PCBA) or exposed to an ambient relative humidity greater than 95%.
For installations which require cables, users can connect the drive as illustrated in Figure 2 Figure 2 Attaching SATA cabling Each cable is keyed to ensure correct orientation. Seagate BarraCuda drives support latching SATA connectors. Seagate BarraCuda Product Manual, Rev. M...
For detailed information about the SATA interface, refer to the “Serial ATA: High Speed Serialized AT Attachment” specification. Hot-Plug compatibility Seagate BarraCuda drives incorporate connectors which enable users to hot plug these drives in accordance with the SATA Revision 3.2 specification. This specification can be downloaded from www.serialata.org.
15 Shall be cleared to zero 4000 14 Shall be set to one 13:1 Reserved for the Trusted Computing Group 0 Trusted Computing feature set is supported Standard Standby timer, IORDY supported and may be disabled 2F00 Seagate BarraCuda Product Manual, Rev. M...
Page 23
0078 Recommended multiword DMA transfer cycle time per word (120 nsec) 0078 Minimum PIO cycle time without IORDY flow control (240 nsec) 0078 Minimum PIO cycle time with IORDY flow control (120 nsec) 0078 Seagate BarraCuda Product Manual, Rev. M...
Page 24
ST2000DM008 = 3,907,029,168 100–103 related information). These words are required for drives that support the 48-bit ST1000DM014 = 1,953,525,168 addressing feature. Maximum value: 0000FFFFFFFFFFFFh. 104-105 ATA-reserved 0000 Physical sector size / logical sector size 6003 Seagate BarraCuda Product Manual, Rev. M...
Page 25
Integrity word xxA5 Advanced Power Management (APM) and Automatic Acoustic Note Management (AAM) features are not supported. See the bit descriptions below for words 63, 84, and 88 of the Identify Drive data. Note Seagate BarraCuda Product Manual, Rev. M...
Page 26
Ultra DMA mode 2 is currently active. Ultra DMA mode 3 is currently active. Ultra DMA mode 4 is currently active. Ultra DMA mode 5 is currently active. Ultra DMA mode 6 is currently active. Seagate BarraCuda Product Manual, Rev. M...
Disable use of SATA features Enable read look-ahead (read cache) feature (default) Report full capacity available At power-on, or after a hardware or software reset, the Note default values of the features are as indicated above. Seagate BarraCuda Product Manual, Rev. M...
S.M.A.R.T. Enable Operations S.M.A.R.T. Disable Operations S.M.A.R.T. Return Status If an appropriate code is not written to the Features Register, the Note command is aborted and 0x04 (abort) is written to the Error register. Seagate BarraCuda Product Manual, Rev. M...
Page 29
Seagate Technology LLC AMERICAS Seagate Technology LLC 47488 Kato Road, Fremont, California 94538, United States, 510-661-1000 Publication Number: 100817550 Rev. M September 2022...