Lexmark Optra Optra T User Manual page 118

A declaration of conformity with the requirements of the Directive has been signed by the
Director of Manufacturing and Technical Support, Lexmark International, S.A., Boigny,
France.
This product satisfies the Class A limits of EN 55022 and safety requirements of EN 60950.
W :
ARNING When a print server is installed, this is a Class A product. In a domestic
environment, this product may cause radio interference, in which case, the user may be
required to take adequate measures.
Without a Network Cable
Federal Communications Commission (FCC) Compliance Informa-
tion Statement
Installed
The Lexmark Optra T laser printer, Type 4069, has been tested and found to comply with
the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. Operation is
subject to the following two conditions: (1) this device may not cause harmful interference,
and (2) this device must accept any interference received, including interference that may
cause undesired operation.
The FCC Class B limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and can radiate
radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no guarantee
that interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
Printer Notices 118