Download Print this page

Looking For Blockages; Disposal Information - Dyson DC24 Operating Manual

Hide thumbs Also See for DC24:

Advertisement

Available languages

Available languages

ASSEMBLY
Lie the vacuum cleaner flat and push on vacuum cleaner head until it clicks.
Stand the vacuum cleaner upright, insert wand into hose and push into place
until it clicks.
Push wand down into hose and attach tools to the side of the vacuum cleaner.
USING YOUR DYSON VACUUM CLEANER
Press foot pedal and recline handle to use. The stabiliser stand will automatically
lift up.
To switch 'ON', depress power button in front of handle.
After cleaning, push the vacuum cleaner into an upright position and stabiliser
wheels will automatically drop. Use the clear bin carrying handle to carry the
vacuum cleaner.
CAUTION:
When returning to the upright position, ensure that the stabiliser wheels are fully
engaged before releasing the vacuum cleaner.
Do not press the cyclone release button while carrying the vacuum cleaner or it
could fall and cause injury.
PLEASE NOTE:
Fine dust such as plaster or flour should only be vacuumed in very small amounts.
Consult your flooring manufacturer's recommended instructions before
vacuuming and caring for your flooring, rugs and carpets. Some carpets will
fuzz if a rotating brushbar is used when vacuuming. If this is the case, we
recommend vacuuming in hard floors mode and consulting with your flooring
manufacturer. (See 'Hard floors or carpets' section.)
If used in a garage for car cleaning, care should be taken to wipe the soleplate
and wheels with a dry cloth after vacuuming to clean off any sand, dirt, or
pebbles which could damage delicate floors.
Do not use the vacuum cleaner to pick up sharp objects, small toys, pins, paper
clips etc.
Store the vacuum cleaner indoors. Do not use or store this vacuum cleaner
below 0˚C (32˚F). Ensure that the vacuum cleaner is at room temperature
before operating.
HARD FLOORS OR CARPETS
The brushbar will always default to 'ON' (spinning) each time you switch on the
vacuum cleaner and recline it for cleaning. The brushbar will automatically stop
if it becomes obstructed. If the brushbar stops during use, please refer to the
'Clearing brushbar obstructions' section.
To switch the brushbar off (e.g. for hard floors), recline the vacuum cleaner and
turn it 'ON', then press the brushbar 'ON/OFF' button – the brushbar will stop
spinning.
HIGH-REACH CLEANING
CAUTION:
Powerful suction can cause the hose to 'pull back' – please take care.
To avoid personal injury and to prevent the vacuum cleaner from falling when
cleaning stairs, do not work with the vacuum cleaner above you on the stairs.
To release the wand, open the wand cap. Extend the red tube until the handle
slides off the vacuum cleaner. Tools can be attached to either the hose or wand.
Ensure wand cap is closed when wand is not in use.
CLEAR BIN EMPTYING
CAUTION:
Switch 'OFF' and unplug the vacuum cleaner before emptying the clear bin.
Empty as soon as the dirt reaches the level of the MAX mark – do not overfill.
To remove the clear bin from the vacuum cleaner press the button at rear of
carrying handle. To release the dirt, press the red clear bin release button.
To minimise dust/allergen contact when emptying, encase the clear bin tightly
in a plastic bag and empty. Remove the clear bin carefully and seal bag tightly,
dispose as normal.
PLEASE NOTE:
Do not use the vacuum cleaner without the clear bin in place.
CLEAR BIN CLEANING
CAUTION:
Switch 'OFF' and unplug the vacuum cleaner before cleaning the clear bin.
Do not immerse the whole cyclone in water or pour water into the cyclones.
Ensure the bin is completely dry before replacing.
PLEASE NOTE:
Do not use detergents, polishes or air fresheners to clean the clear bin.
Do not put the clear bin in a dishwasher.
When vacuuming, certain carpets may generate small static charges in the clear
bin. These are entirely harmless and are not associated with the mains supply.
To minimise any effect from this, do not put your hand or insert any object into
the clear bin unless you have first emptied it and rinsed it out with cold water.
Clean the shroud with a cloth or dry brush to remove lint and dust.
WASHING YOUR FILTERS
DO THIS EVERY MONTH.
CAUTION:
Switch 'OFF' and unplug the vacuum cleaner before removing the filters.
Ensure filters are completely dry before refitting to the vacuum cleaner.
This machine has two filters, located as shown. It is important to check your
filters regularly and wash at least every 1 month according to instructions to
maintain performance.
The filter in the ball should be rinsed and tapped out until the water runs clean,
then tapped out again to ensure all excess water is removed. This will normally
require up to 10 rinse cycles. Please leave to dry completely for 24 hours.
12
12
PLEASE NOTE:
It is normal for the filter in the ball to turn grey in colour. The filters may require
more frequent washing if vacuuming fine dust.
Do not use detergents to clean the filters.
Do not put the filters in the dishwasher, washing machine, tumble dryer, oven,
microwave or near an open flame.

LOOKING FOR BLOCKAGES

CAUTION:
Switch 'OFF' and unplug the vacuum cleaner before checking for blockages.
Please ensure the vacuum cleaner is upright before removing hose or airway
inspection parts.
Beware of sharp objects when clearing blockages.
Refit all parts of the vacuum cleaner securely before using.
PLEASE NOTE:
Clearing blockages is not covered by your vacuum cleaner's limited warranty.
If any part of your vacuum cleaner becomes blocked, it may overheat and then
automatically shut off. Unplug the vacuum cleaner and leave to cool down.
Clear blockage before restarting.
CLEARING BRUSHBAR OBSTRUCTION
CAUTION:
Switch 'OFF' and unplug the vacuum cleaner before clearing the brushbar
obstructions. If your brushbar is obstructed, it may shut off. If this happens you
will need to remove brushbar as shown and clear any obstructing debris.

DISPOSAL INFORMATION

Dyson products are made from high grade recyclable materials. Please dispose
of this product responsibly and recycle where possible.
GUARANTEE - TERMS AND CONDITIONS
DYSON CUSTOMER CARE
After registering for your free 5 year guarantee, your Dyson vacuum cleaner will
be covered for parts and labour for 5 years from the date of purchase, subject to
the terms of the guarantee.
If you have any query about Dyson vacuum cleaner, call the Dyson Customer
Care Helpline with your serial number and details of where/when you bought
the vacuum cleaner. Your serial number can be found behind the filter. Most
queries can be solved over the phone by one of our trained Dyson Customer
Care Helpline staff.
PLEASE REGISTER AS A DYSON VACUUM OWNER
THANK YOU FOR CHOOSING TO BUY A DYSON VACUUM CLEANER
To help us ensure you receive prompt and efficient service, please register as a
Dyson vacuum owner. There are two ways to do this:
Online at www.dyson.com
By calling the Customer Care Helpline:
This will confirm ownership of your Dyson vacuum cleaner in the event of an
insurance loss, and enable us to contact you if necessary.
LIMITED 5 YEAR GUARANTEE
TERMS AND CONDITIONS OF THE DYSON 5 YEAR LIMITED GUARANTEE.
WHAT IS COVERED
The repair or replacement of your Dyson vacuum cleaner (at Dyson's discretion)
if your Dyson vacuum cleaner is found to be defective due to faulty materials,
workmanship or function within 5 years of purchase or delivery (if any part is no
longer available or out of manufacture Dyson will replace it with a functional
replacement part).
Use of the Dyson vacuum cleaner in the country of purchase.
You must provide proof of (both the original and any subsequent) delivery/
purchase before any work can be carried out on your Dyson vacuum cleaner.
Without this proof, any work carried out will be chargeable. Please keep your
receipt or delivery note.
WHAT IS NOT COVERED
Dyson does not guarantee the repair or replacement of a product as a result of:
Normal wear and tear (e.g. fuse, belt, brush bar, batteries etc).
Accidental damage, faults caused by negligent use or care, misuse, neglect,
careless operation or handling of the vacuum cleaner which is not in accordance
with the Dyson Operating Manual.
Blockages – please refer to the Dyson Operating Manual for details of how to
unblock your vacuum cleaner.
Use of the vacuum cleaner for anything other than normal domestic
household purposes.
Use of parts not assembled or installed in accordance with the instructions
of Dyson.
Use of parts and accessories which are not Dyson Genuine Components.
Faulty installation (except where installed by Dyson).
Repairs or alterations carried out by parties other than Dyson or its
authorised agents.
If you are in any doubt as to what is covered by your guarantee, please call the
Dyson Customer Care Helpline.
SUMMARY OF COVER
The guarantee becomes effective at the date of purchase (or the date of delivery
if this is later).
All work will be carried out by Dyson or its authorised agents.
Any parts which are replaced will become the property of Dyson.
The repair or replacement of your vacuum cleaner under guarantee will not
extend the period of guarantee.
The guarantee provides benefits which are additional to and do not affect your
statutory rights as a consumer.

Advertisement

loading