Custom Bin Names; Universal Setup - Lexmark X646E Menus And Messages Manual

Custom Bin Names

This menu item is used to define a custom name for each output bin based on a person or the type of print media assigned
to exit to a specific output bin.
Menu item Purpose
<user-defined Specifies the custom name of output
Custom Bin Name> bin <x>, where x is 1–10 based on the
MFP model or the optional finisher, if
one is attached.

Universal Setup

These menu items are used to specify the height and width of the Universal Paper Size. When the height and width for
Universal Paper Size are specified, the MFP uses the Universal setting like other paper sizes, including support for duplex
and n-up. For more information on n-up, see Multipage Print.
Menu item Purpose
Units of Measure Determines the unit of measure
used to enter the Universal Height
and Width.
Portrait Width Sets the portrait width of the
universal media.
Note: If the value set exceeds the
maximum width, the MFP uses the
maximum value allowed in inches or
millimeters.
Portrait Height Sets the portrait height of the
universal media.
Note: If the value set exceeds the
maximum height, the MFP uses the
maximum value allowed in inches or
millimeters.
Feed Direction Specifies the feed direction of the
Universal Paper Size.
Using the MFP menus
Values and descriptions
[user-defined
name], such as:
Company's bin
Lawyer's bin
Mary's bin
Stephen's bin
Values and descriptions
Inches
Millimeters
3–14.17 inches in
0.01 inch increments
76–360 mm in 1 mm
increments
3–14.17 inches in
0.01 inch increments
76–360 mm in 1 mm
increments
Short Edge*
Long Edge
Paper Menu
27
The custom output bin must be able
to accept the type of print media
assigned to exit to the defined bin in
order for a user-defined name to be
assigned.
Inches is the US default, and
Millimeters is the international default.
Shows either inches or millimeters
from the Units of Measure setting;
8.5 inches is the US default, and
216 mm is the international default.
Shows either inches or millimeters
from the Units of Measure setting;
14 inches is the US default, and
356 mm is the international default.
Feed Direction is only shown if the
Long Edge value is available. Long
Edge exists if the longest edge is
shorter than the maximum physical
width that the tray can accommodate.
See Duplex Bind on page 77 for
more information about short and long
edges.