Network Troubleshooting; Printing A Network Setup Page - Lexmark Platinum Pro905 Reference Manual

Cannot print through USB
If the "Before you troubleshoot" checklist does not solve the problem, then try one or more of the following:
C USB
HECK THE CONNECTION
1
Check the USB cable for any obvious damage. If the cable is damaged, then use a new one.
2
Firmly plug the square end of the USB cable into the back of the printer.
3
Firmly plug the rectangular end of the USB cable into the USB port of the computer.
The USB port is marked with a
Note: If you continue to have problems, then try another USB port on the computer. You may have connected to
a defective port.
M USB
AKE SURE THE
1
Click , or click Start and then click Run.
2
In the Start Search or Run box, type devmgmt.msc.
3
Press Enter, or click OK.
The Device Manager opens.
4
Click the plus sign (+) beside Universal Serial Bus controllers.
If USB Host Controller and USB Root Hub are listed, then the USB port is enabled.
For more information, see the computer documentation.
R
EMOVE AND REINSTALL THE PRINTER SOFTWARE

Network Troubleshooting

If you are having trouble setting up your printer on a network, print a network setup page, and then see the complete
network troubleshooting information in the Network Getting Started Guide or the comprehensive User's Guide
available on the installation software CD.

Printing a network setup page

A network setup page lists the configuration settings of the printer, including the IP address and MAC address of the
printer.
1
Load plain paper.
2
From the home screen, navigate to Print Setup Page:
> Network Setup > Print Setup Page
The network setup page prints.
USB symbol.
PORT IS ENABLED IN
Troubleshooting
W
INDOWS
43