Lexmark 3300 Series Install Manual

3300 Series All-In-One
Unpack your All-In-One.
1
Note: Contents may vary based on geography.
Note: You may need to purchase a USB
cable separately.
Press to scroll to your language
4
and then press .
Remove the sticker and tape
8
from the print cartridges.
1 2
1
2
See the troubleshooting guide on the reverse of this sheet.
Your All-In-One may include a
photo cartridge instead of a
black print cartridge.
Before you continue, remove the
photo cartridge from the print
cartridge storage unit.
Note: Save the print cartridge
storage unit to protect any open
cartridges not in use.
Lift the paper support and extend
5
the paper exit tray.
1 Open the cartridge lids by pressing the front tabs.
9
2 Insert the cartridges and push them down firmly.
3 Snap the lids tight.
Left: Right:
photo color
or only
black
1
CAUTION: Do not set up this product or make any electrical or cabling connections, such as the power supply cord or
telephone, during a lightning storm.
• Use only the power supply provided with this product or the manufacturer's authorized replacement power supply.
• Connect the power supply cord to an electrical outlet that is near the product and easily accessible.
• Refer service or repairs, other than those described in the user documentation, to a professional service person.
Connect the power cord to the power supply.
2
1
1 Pull back the transparent deflector.
6
2 Load the paper flat and to the right.
3 Squeeze the paper guide. Slide it
to the right until it is snug.
2
3
1
Close the scanner unit.
10
2
3

Safety information

www.lexmark.com
Make sure the power light is on.
3
2
Lift the scanner unit.
7
2
1
3
You may discard the page
after it prints.
Steps 12–15
*23A0170*
Press to print
11
an alignment page.