Restoring Factory Defaults - Lexicon DC-2 Quick Reference Manual

DC-2 Digital Controller Quick Reference Guide
Alternate Remote Control Functions
Make a note of any programs, setup or calibration
values you want to re-enter, as this procedure will
reset all DC-2 parameters to their default states.
as well as all setup and calibration values.
Lexicon Part # 070-13228 Rev 1

Restoring Factory Defaults

Lexicon, Inc. 3 Oak Park • Bedford MA 01730-1441 USA • Tel: (781) 280-0300 • Fax: (781) 280-0490 • www. lexicon.com
Using the remote, turn the
unit OFF, then ON, then
press and hold MUTE. The
on-screen display will
read:
FACTORY PRESETS MENU
EXIT
RESTORE DEFAULTS
Record/Zone 2 Control
Zone 2 controls can be accessed from either the DC-2 front
panel, or the remote control by pressing and holding down
the Record/Zone 2 button in conjunction with the buttons
shown below.
To resume normal opera-
tion without restoring all de-
faults, press SELECT.
To clear and reload all pre-
set effects and all factory
settings, use to highlight
RESTORE DEFAULTS,
and press SELECT.
When the message:
FACTORY PRESETS MENU
FACTORY DEFAULTS
RESTORED
is displayed, press DONE to
return to normal operation.
© 1999 Lexicon, Inc