Table of Contents
Advertisement
DC-1 Version 3 Digital Controller
Although the DC-1 memory is cleared before it leaves the factory, it is good
practice to restore the factory defaults with the following procedure before
system configuration.
Turn the DC-1 OFF with the remote control. Turn the unit back ON and
immediately press and hold the MUTE button on the remote. (Make sure
you do not block the infrared receiver on the DC-1 front panel.) The display
will read:
Press
to highlight RESTORE DEFAULTS, then press SELECT. This will
clear and reload all preset effects and all factory settings of Volume,
Balance, Contrast, Configuration, etc. When the message FACTORY DE-
FAULTS RESTORED is displayed, press DONE to return to normal opera-
tion.
In the main menu, press SELECT to open the Equalization menu which
contains Bass, Treble and Tilt controls, and a Loudness parameter.
Bass and Treble level controls are provided to compensate for inconsisten-
cies in source material, rather than variations in room conditions. The BASS
LEVEL control allows a boost or cut of as much as 6dB below 250Hz. The
TREBLE LEVEL control allows a boost or cut of 6dB above 1.5kHz. To select
either control for adjustment, use
and use
or
to adjust the setting.
These controls do not affect the sound of rear or side speakers.
or
to select the control, press SELECT,
System
System
Configuration
Configuration
Restore
Factory Defaults
Equalization
Bass and Treble Level
2
11
Advertisement
Table of Contents
