Speco D4VN User Manual page 21

Select Daylight Saving using the mouse or the remote control and select the appropriate
daylight saving time zone. The options are:
OFF: Daylight saving is turned off.
ON: Applies the USA daylight saving time.
Caution
- Do not set the start time to 23:00 for DLS.
- DLS cannot be applied if the date of Begin and End is the same.
Enable/Disable remote access through the network.
Client Access
NTP NTP (Network Time Protocol) which synchronizes the time of the computer systems over
Setup variable-latency data networks.
Primary SNTP Server: Input the address of the primary NTP time-server.
Secondary SNTP Server: Input the address of the secondary NTP time-server.
Time Zone: NTP synchronizes with GMT (Greenwich Mean Time) regardless of
geography, user must set their own time difference.
Connection Mode: Select the NTP time-server connection mode from Time, Interval,
and Once.
-
-
-
Connection Period: Set the time (12:00 AM ~ 11:00 PM) when select "Time" on
Connection Mode.
DVR sends e-Mail Notification when the NTP server time is faster than the system
time with bellow message.
- Select Begin or End using the remote control and press the "ok" button.
TIME – Refresh the time at the designated time (e.g. 01:00 AM)
INTERVAL – Every 1 hour ~ 24 hours
ONCE – Synchronizes time only once. NTP will not synchronize unless the
Connection Mode is changed.
21