Leviton i Series e User Manual page 23

A8 The control level from analog input submaster 8 has created the highest level.
A9 The control level from analog input submaster 9 has created the highest level.
A10 The control level from analog input submaster 10 has created the highest level.
A11 The control level from analog input submaster 11 has created the highest level.
A12 The control level from analog input submaster 12 has created the highest level.
PAN The control level from the active panic scene has created the highest level.
BKP The control level from the active backup scene has created the highest level.
D I M = 0 1
D M X
D M X = 0 0 1
[
The small "f" indicates that Luma-Net is providing readback (feedback) to the control stations. It usually
appears at the end of the Luma-Net address as it is a Luma-Net function. In this screen there is no room
there so it appears after the controlling signal source.
D I M = 0 1
D M X f
D M X = 0 0 1
[
This is the maximum level the dimmer will ever go to, regardless whether any of the control inputs tell it to go
higher. This feature is useful for extending lamp life, for chandelier circuits or other places where bulb
replacement is awkward. A maximum output setting of 85% will increase the lamp life of most incandescent
lamps by a factor of 10. The standard patches (address thumb -wheel positions 1-15) force this value to full.
If you which to change this value, then you must first enter a custom patch for the rack (see section 2.31).
When you are finished, select the custom patch using thumb -wheel address 0, which will enable maximum
levels, minimum levels, and non-dims
Note: If the selected dimmer curve contains a cutoff value, the MAX=FL & MIN=00 spaces will be replaced
with CUTOFF=02 indicating that the cutoff is at 2%.
D I M = 0 1
D M X f
D M X = 0 0 1
[
The small "s" indicates that the value assigned to the dimmer displayed is the same as the global (system-
wide) value. If the value is changed here the "s" will disappear. If the global value is then changed this value
will remain. To re-unite this value with the global value, change this value to match the current global value.
The "s" will reappear.
D I M = 0 1
D M X f
D M X = 0 0 1
[
This is the minimum level the dimmer will ever go to, regardless whether any of the control inputs tell it to go
lower. This feature is useful for extending lamp life by eliminating the shock of cold tungsten inrushes, and
i Series e Users Guide
LIT-31903-00
* V I
f M A X = F L s
M K X
E D I T ] [ F O R C E ]
* V I
M A X = F L
M K X
E D I T ] [ F O R C E ]
* V I
M A X = F L
M K X
E D I T ] [ F O R C E ]
* V I
M A X = F L s
M K X
E D I T ] [ F O R C E ]
E W * L V L = 0 0
M I N = 0 0 s
L U M = 0 0 0 1
[ B A C K ]
E W * L V L = 0 0
s M I N = 0 0 s
L U M = 0 0 0 1
[ B A C K ]
E W * L V L = 0 0
s M I N = 0 0
L U M = 0 0 0 1
[ B A C K ]
E W * L V L = 0 0
M I N = 0 0
L U M = 0 0 0 1
[ B A C K ]
s
s
Page 23 of 35