Auxiliary Power Points - Ford VN TRANSIT CUSTOM 2013 Owner's Manual

WARNINGS
If used when the engine is not
running, the battery will lose charge.
There may be insufficient power to
restart the engine.
Do not plug optional electrical
accessories into the cigar lighter
socket. Incorrect use of the lighter
can cause damage not covered by your
warranty, and can result in fire or serious
injury.
Note: Do not insert objects other than an
accessory plug into the power point. This
will damage the outlet and blow the fuse.
Note: Do not hang any type of accessory or
accessory bracket from the plug.
Note: Do not use the power point over the
vehicle capacity of 12 volt DC 10 amp or a
fuse may blow.
Note: Do not use the power point for
operating a cigar lighter element.
Note: Incorrect use of the power point can
cause damage not covered by your
warranty.
Note: Always keep the power point caps
closed when not in use.
Note: The power point will turn off after 30
minutes if the ignition is on without the
engine running. Keep the engine running or
cycle the ignition to keep the power point
on.
Run the engine for full capacity use of the
power point. To prevent the battery from
losing charge:
Do not use the power point longer than
necessary when the engine is not
running.
Do not leave devices plugged in
overnight or when your vehicle is
parked for extended periods.
Tourneo Custom/Transit Custom (TTF) Vehicles Built From: 01-09-2013, enAUS, Edition date: 12/2014

Auxiliary Power Points

66
Locations
E145568
Power points may be found:
on the instrument panel
inside the center console storage bin
on the D-pillar or rear trim.
AC Power Point
WARNING
Do not keep electrical devices
plugged in the power point whenever
the device is not in use. Do not use
any extension cord with the AC power
point, since it will defeat the safety
protection design provided by the cap and
twist tab. Doing so my cause the power
point to overload due to powering multiple
devices that can reach beyond the 150
watt load limit and could result in fire or
serious injury.
Note: The power point will turn off after 30
minutes if the ignition is on without the
engine running. Keep the engine running or
cycle the ignition to keep the power point
on.
(If Equipped)