Stop The Engine; Maintenance Schedule - Briggs & Stratton 120000 Operator's Manual

Table of Contents

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 1
WARNING 
Fuel and its vapors are flammable and explosive. Fire or explosion could result
in burns or death.
When you start the engine
Make sure that the spark plug, muffler, fuel cap and air cleaner (if equipped)
are correctly installed.
Do not crank the engine with the spark plug removed.
If the engine is flooded, set the choke (if equipped) to the OPEN or RUN
position. Move the throttle (if equipped) to the FAST position and crank until the
engine starts.
If there is natural or LP gas leakage in the area, do not start the engine.
Because vapors are flammable, do not use pressurized starter fluids.
WARNING 
Rotating parts can entangle hands, feet, hair, clothing, or accessories and result
in traumatic amputation or laceration.
Operate equipment with the guards correctly installed.
Keep hands and feet away from rotating parts.
Remove jewelry and make sure that long hair is away from all rotating parts.
Do not wear loose clothes or items that could become caught.
WARNING 
Fast retraction of the starter cord (kickback) will pull your hand and arm to the
engine faster than you can let go. Broken bones, fractures, bruises or sprains
could result.
To prevent kickback when you start the engine, pull the starter cord slowly until
resistance is felt and then pull quickly.
Before you start the engine, disconnect or remove all external equipment and
engine loads.
Make sure that direct-coupled equipment components, such as, but not limited
to, blades, impellers, pulleys, and sprockets, are correctly attached.
Types of Start Systems
Before you start the engine, you must know the type of start system on your engine.
Your engine will have one of these types.
®
ReadyStart
and 1-Step Start System: These systems have a temperature
controlled automatic choke. It does not have a manual choke or a primer.
Choke System: This system has a choke to be used in cool temperatures. It
does not have a primer.
To start your engine, follow the instructions for your type of starting system.
NOTE: Your equipment could have remote controls. Refer to the equipment manual for
location and operation of remote controls.
®
Choke, ReadyStart
and 1-Step Start System
1.
Check the engine oil. Refer to the Check the Oil Level section.
2.
Make sure that the equipment drive controls, if installed, are disengaged.
3.
Turn the fuel shut-off (A, Figure 7), if installed, to the OPEN position.
4.
Move the throttle control (B, Figure 7), if installed, to the FAST position. Operate the
engine in the FAST position.
5.
Move the choke control (F, Figure 7), if installed, to the CLOSED position.
6.
Push the stop switch (D, Figure  7), if installed, to the ON position.
7.
Hold the engine stop lever (C, Figure 8), if installed, against the handle
8.
Tightly hold the starter cord handle, if installed (E, Figure 7). Pull the starter cord
handle slowly until resistance is felt, and then pull quickly.
9.
Turn the electric start switch, if installed, to the ON / START position.
10. When the engine is warm, move the choke control (F, Figure 7) to the OPEN / RUN
position.

Stop the Engine

WARNING 
Fuel and its vapors are flammable and explosive. Fire or explosion could result in
burns or death.
Do not choke the carburetor (if equipped) to stop the engine.
1.
Release the engine stop lever (E, Figure 8), if installed.
2.
Move the stop switch (D, Figure 7), if installed, to the OFF position.
6
3.
Move the throttle control (B, Figure 7), if installed, to the STOP position.
4.
Turn the electric start key, if installed, to the OFF / STOP position. Remove the
key and keep it in a safe location.
5.
Wait for the engine to stop. Move the fuel shut-off (A, Figure 7), if installed, to the
CLOSED position.
Maintenance
Maintenance Information
WARNING 
Fuel and its vapors are flammable and explosive. Fire or explosion could result in
burns or death.
During maintenance if it is necessary to tilt the unit, make sure that the fuel tank, if
mounted on the engine, is empty and that the spark plug side is up. If the fuel tank is not
empty, leakage can occur and could result in a fire or an explosion. If the engine is tilted
in a different direction, it will not easily start because of oil or fuel contamination of the air
filter or the spark plug.
WARNING 
Accidental engine spark can cause an electric shock, fire or explosion and could
result in entanglement, traumatic amputation or laceration.
Before you make adjustments or repairs:
Disconnect all spark plug wires and keep them away from the spark plugs.
Disconnect the battery wire from the negative battery terminal (only engines with
electric start).
Use only the correct tools.
When you check for spark:
Use an approved spark plug tester.
Do not check for spark with the spark plug removed.
WARNING 
Replacement parts must be of the same design and installed in the same position as the
original parts. Other parts could result in damage or an injury.
NOTICE 
All the components used to build this engine must remain in place for correct operation.
See a Briggs & Stratton Authorized Service Dealer for all maintenance and servicing of
the engine and engine parts.
Emissions Control Service
For maintenance, replacement, or repair of emissions control devices and
systems, contact a qualified off-road engine repair establishment or service
technician. However, for "no charge" emissions control service, the work must be done
by a factory authorized dealer. Refer to the Emissions Control Statements.

Maintenance Schedule

First 5 Hours
Change the oil (not necessary on Just Check & Add Models
Intervals of 8 Hours
Check the engine oil level.
Clean the area around muffler and controls.
Clean the air intake grille.
Intervals of 50 Hours or Annually
1
Clean the air filter
.
Clean the pre-cleaner (if installed)
Change the engine oil (not necessary on Just Check & Add Models
Replace the oil filter (if installed) (not necessary on Just Check & Add
TM
Models
).
Service the exhaust system.
Intervals of 200 Hours
1
Replace the air filter
.
Replace the pre-cleaner (if installed)
Annually
TM
).
1
.
TM
1
.
BRIGGSandSTRATTON.COM
).

Advertisement

Table of Contents
loading

This manual is also suitable for:

140000

Table of Contents