Table of Contents
Advertisement
1.3.1
Preparing the DSP96002ADM
Because all electronic components are sensitive to the effects of
electrostatic discharge (ESD) damage, correct procedures should be
used when handling all components in this kit and inside the
supporting personal computer. Use the following procedures to
minimize the likelihood of damage due to ESD:
– Always handle all static-sensitive components only in a protected
area, preferably a lab with conductive (anti-static) flooring and
bench surfaces.
– Always use grounded wrist straps when handling sensitive
components.
– Never remove components from anti-static packaging until
required for installation.
– Always transport sensitive components in anti-static packaging.
Locate the twenty-seven jumper blocks JG1–JG27 on the DSP96002ADM board, as
shown in Figure 1-1 on page 1-6. Table 1-1 describes the default jumper and switch
settings when shipped from the factory.
Read the technical summary in Section 2 of this manual for additional information
about the DSP96002ADM board and its components.
MOTOROLA
CAUTION
DSP96002ADMUM/AD, Preliminary
Quick Start Guide
Installation Procedure
1-5
Advertisement
Table of Contents
