Table of Contents
Advertisement
Setting
Continued
Pre-setting 2 (pairing)
Pair the transmitter to be used with one of the receivers for which "Pre-setting 1" has been
completed.
Standby screen after the completion of pre-setting
Group ID (Cast Group set as above) and "Mode: Multicast" are displayed at the bottom.
Since the Multi-screen mode is not supported, the operation guide display is changed.
Since the transmitter during Multicast is connected via external wireless LAN, the number of
connections is displayed here.
Note
• When the Multicast setting is changed, pairing of the transmitter is required again.
• Depending on the network connection status, delay or other problems may occur in Multicast video. If the delay
concerns you, try wired LAN connection between the receiver and the router.
• When [Wireless Display] is set to [On], the Multicast function cannot be used. Accordingly, [Multicast] cannot
be set to [On].
• When [Multicast] is set to [On], the following functions are not supported.
- Multi-screen mode
- Operation with HID devices
- Mirroring from the PressIT application for Android/iOS
- Downloading of the pairing file
• Please note that when communication between the router and the receiver is unavailable for a certain period
of time, [Multicast] is forcibly set to [Off].
When communication between the router and the receiver is unavailable, a message is displayed in the
center of the standby screen as shown below.
If communication between the router and the receiver cannot be resumed while the message is displayed,
[Multicast] is forcibly set to [Off], and the receiver restarts. (When communication can be resumed, the
Multicast setting can be maintained.)
●
Download Pairing File
Download the pairing file and save it on a USB flash drive.
After downloading is complete, perform step 5 and the subsequent steps in "Pairing by saving a file to the USB
memory" (page 21) to copy the pairing file to the transmitter.
The receiver and transmitter of the TY-WPS1/TY-WPS1W basic set are paired at the time of shipment. When the
transmitter is initialized or a new transmitter is additionally purchased, pairing with the receiver is required before
using.
40
40
English
Advertisement
Table of Contents
