Replacing a memory module
To replace a memory module:
1. Remove the computer cover. See "Removing the computer cover" on page 7.
2. Locate the memory module connectors. See "Locating components" on page 1.
3. Remove the memory module being replaced by opening the retaining clips as
4. Position the new memory module over the memory connector. Make sure the
5. Go to "Completing the installation" on page 26.
Attention:
Do not remove the computer cover or attempt any repair before reading the "Important
safety information" in the Safety and Warranty Guide that was included with your computer.
To obtain copies of the Safety and Warranty Guide, go to the Support Web site at
http://www.lenovo.com/support.
Note: For this procedure, it helps to lay the computer on its side.
shown.
notch 1 on the memory aligns correctly with the connector key 2 on the
system board. Push the memory module straight down into the connector until
the retaining clips close.
Chapter 2. Replacing hardware
15