Table of Contents
Advertisement
Define default stacking in the high capacity stacker
4. Use the [Top tray - Header orientation] and [Stack tray - Header orientation] functions to
indicate if the header of the prints points to the front side of the printer or to the back side of
the printer by default.
• [Header-up]: header of printed document pages points to the back side of printer.
• [Header-down]: header of printed document pages points to the front side of printer
[105] Default header orientation
5. Use the [Top tray - Preferred feed edge] and [Stack tray - Preferred feed edge] functions to
indicate if the long or short side of the sheet points refers to the feed direction of the sheets
by default.
• [Long-edge feed (LEF)]: long-edge feed direction.
• [Short-edge feed (SEF)]: long-edge feed direction.
[106] Default feed direction
6. Use the [Stack tray - Offset stacking] function to define the offset value. When the offset value
is '0' offset stacking is disabled. The default offset value is 15 mm / 0.59".
[107] Offset stacking
7. Use the [Minimum filling level] function to define the filling level in the stack tray.
The minimum filling rate is a percentage of the maximum stack height. The default value is
80%. The high capacity stacker ejects the stack as soon as the stack height exceeds the
minimum filling rate. The minimum filling rate is active in case the high capacity stacker
ejects a stack when the stack tray is full.
88
Chapter 5 - Define defaults
VarioPrint i-series MICR
Advertisement
Table of Contents
