Related Manuals for Planet ERT-805
Summary of Contents for Planet ERT-805
-
Page 1: Table Of Contents
Table of Contents Chapter 1 Package Contents Unpacking the router Hardware install section Connect a Serial Device Chapter 2 Terminal Setup Chapter 3 Logon to the Console Chapter 4 Configure Password Chapter 5 Configuration IP Address... - Page 2 This page is intentionally left blank...
-
Page 3: Chapter 1 Package Contents
CD- ROM. Unpacking the router Open the box of the ERT-805 router and carefully unpack it. The box should contain the following items: • ERT-805 Serial WAN Router •... -
Page 4: Hardware Install Section
Hardware install section To install ERT-805 serial router, just following the step: • Connect an Ethernet device • Connect a Serial device • Connect a terminal or PC • Connect the power supply Connect a Serial Device WAN Option WAN Encapsulation... -
Page 5: Chapter 2 Terminal Setup
PC or notebook computer and to serial (console) port of the device. When the connection between the PC and ERT-805 is ready, run the Hyper Terminal and configure its communication parameters. It can be accessed from the Start menu. Click START, then Programs, Accessories and then Hyper Terminal. - Page 6 This page is intentionally left blank...
-
Page 7: Chapter 3 Logon To The Console
Once the terminal has connected to the device, power on the device, the terminal will display that it is running POST (Power on self-test) procedures. Then, screen as below will show up. The ERT-805 will prompt with “>”. This means ERT- 805 is in operating mode now. - Page 8 This page is intentionally left blank...
-
Page 9: Chapter 4 Configure Password
Configure Password 1. Once log on to the console, the following screen displayed. Fig 1: The privilege Screen of ERT-805 2. Types “config terminal” to enter configuration mode. ERT-805 will prompt “<console>#” Fig 2: Configuration mode Screen 3. Then type command enable password “abc” to setup the enable privilege password where abc is the password. - Page 10 This page is intentionally left blank...
-
Page 11: Chapter 5 Configuration Ip Address
And key in “end” to close the configure mode and “wr” to write the setting and make the setting activated right away. Now ERT-805 is with a IP address and ready to have further configuration, You can either stay in the console interface for setup or using Telnet too. - Page 12 This page is intentionally left blank...
- Page 14 2010-000033-000...