Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Planet EH-2400
Summary of Contents for Planet EH-2400
- Page 1 EH-2400 Ethernet Hub User’s Manual...
- Page 2 All the trademarks and trade names mentioned in this manual are the property of their respective companies. Revision The information in this manual is subject to change without notice. User's manual for PLANET Ethernet Hub : EH-2400 Rev 2.0 (Nov. 1999) Part No. EM-2400V2...
-
Page 3: Table Of Contents
............................1 RODUCT EATURES ............................1 NPACKING THE CHAPTER 2 GENERAL DESCRIPTION ....................2 EH-2400..........................2 RONT ANEL OF ..............................2 INDICATOR EH-2400 ...........................3 ANEL OF CHAPTER 3 INSTALLATION ........................4 EH-2400 ......................4 ETTING EADY TO NSTALL THE EH-2400 ........................4 REPARE TO NSTALL EH-2400 I .............................5... -
Page 4: Chapter 1 Intorduction
INTORDUCTION Product Introduction EH-2400 is a standard Ethernet concentrator that retimes and re-transmits the signal to each network station on the LAN. It simplifies the implementation of twisted-pair Ethernet compatible networks following the IEEE 802.3 10Base-2/5/T CSMA/CD standard. Each Hub has twenty-four modular RJ-45 STP ports and one BNC port . -
Page 5: Chapter 2 General Description
GENERAL DESCRIPTION Front Panel of EH-2400 On the front panel of EH-2400, there are Power, Collision, Jabber, utilization LEDs. For each RJ-45 STP port, there are two LED indicators - TX/RX LED and Partition LEDs. These LEDs help in diagnosing line troubles and indicate the status of data transmission. -
Page 6: Chapter 3 Installation
BNC port and Coaxial Thin Cable EH-2400’s thin coaxial port can be connected to either a computer or another hub. In order to user the thin coaxial port, you will need one thin coaxial cable, two 50-ohm terminators and T-connectors. -
Page 7: Eh-2400 Installation
EH-2400 Installation Follow the instructions below to set up EH-2400. Step 1. Select a suitable place to put the hub or to install. Make sure there is an AC outlet nearby. Step 2. Power off all of the computers, hubs, or other devices that will be connected to the hub. -
Page 8: Chapter 4 Troubleshooting
CHAPTER 4 TROUBLESHOOTING SYMPTOM: The power LED is not lit. SOLUTION: If the power LED is not lit after the power cord is plugged into the concentrator and the power outlet, there may be a power fault. 1.First verify if there is power at the power outlet by plugging in a device which is known to operate. -
Page 9: Chapter 5 Product Specification
CHAPTER 5 PRODUCT SPECIFICATION Standard : Ethernet 10Base-2/5/T Compliance Media Supported : Category-3/4/5 STP/UTP cable Thick Cable RG-58 coaxial cable Interface : 24-port 10Base-T STP port 1-port 10Base-T UpLink port 1-port AUI port 1-port BNC port LEDs 1-Power, collision, Jabber LED 8-Utilization LEDs 24-TX/RX LEDs...