Advertisement
Operation
Operating Instructions
Dis-
Func-
play
tion
Power /
A
-
Standby
Sleep
B
Timer
Flame Effect
F1 / F2 /
C
FP
-
Off
Log Effect
Pulsing
Logs
D
Static
logs
-
Off
-
E
On / Off
Low
Heat
F
High
Heat
Cool
Blow
-
Off
10
Description
Press Once to turn the product 'ON'.
Press a second time to p
ss a second time to put the product into 'STANDBY'.
(When returning from 'STANDBY' mode the product will return to previous settings
unless the product has been unplugged, in which case it will reset to factory settings)
Press multiple times to change the 'SLEEP TIMER' in 0.5 hr increments from 0.5
hr to 8.0 hr before turning off. The remaining time on the 'SLEEP TIMER' displays.
(This icon is Green in colour)
'FLAME EFFECT' button cycles the unit sequentially through the 4 settings. LOW
FLAME, HIGH FLAME, DEMO MODE and OFF.
'FLAME EFFECT' Button
This button will change the brightness of the flame effect.
There are 3 brightness settings shown as F1, F2, FP.
F1 will run the flame effect at a low brightness level (The display will show F1).
F2 will run the flame effect at a high brightness setting (The display will show F2).
FP will slowly pulse the flame effect between low and high brightness (The display
will show FP).
This will turn the flame effect off. If the heater is running, the display will activate and
remain active to read the set temperature and show if the product is on LOW HEAT/
HIGH HEAT/COOL BLOW.
'LOG EFFECT' button cycles the unit sequentially through the 3 settings, 'PULSING
LOGS', STATIC LOGS', 'COOL BLOW', and 'OFF.'
This setting will make the logs pulse. (The display will show FP).
This setting will make the logs stay lit. (The display will show FS).
This setting will turn the logs off.
This button cycles the top light 'on' and 'Off'
'HEAT' button cycles the unit sequentially through the 4 settings: LOW HEAT, HIGH
HEAT, COOL BLOW and OFF. The heat setting will be indicated by an icon in the display.
When the flame effect is 'ON' the display will turn off after 5 seconds, however if the
heater is being used independently of the flame effect. The low heat or high heat icon
will appear continuously in the display.
This setting will run the heater at 'LOW HEAT' this setting will be indicated by the 'LOW
HEAT' icon and the letters 'LO' appearing in the display. To adjust the temperature
setting the Temp Down or Temp Up buttons described below must be used.
(This icon is Orange in Colour)
This icon in the display indicates 'HIGH HEAT' this setting will be indicated by the 'HIGH
HEAT' icon and the letters 'HI' appearing in the display. To Adjust the temperature
setting the Temp Down or Temp Up buttons described below must be used.
(This icon is Red in Colour)
This icon in the floating display indicates 'COOL BLOW' this setting will be indicated
by the 'COOL BLOW' icon and the letters 'CB' appearing in the display.
(This icon is Blue in Colour)
This switches the heater and blower 'OFF', no icon will be displayed in the display.
Note the blower will run for 10-20 seconds after being turned off, this is to ensure the
product cools down safely.
Advertisement
