Operation; Making The Connection - Whistler XP600i Owner's Manual

Making the Connection.

This inverter is designed to connect to your 12 volt battery using the
supplied #8 AWG gauge cables.
1. Make certain that the inverter rocker switch is in the center
OFF (O) position.
2. Connect the cables to the power input terminals at the
rear of the inverter and tighten the screws to make a se-
cure connection. Do not use tools to tighten these screws.
3. Connect the cable from the (BLACK) Negative (-) terminal
on the inverter to the Negative (-) terminal on the 12 volt
power source. Make certain the connection is secure.
4. Confirm that the cable you have just installed is properly
connected. Specifically, make certain that the cable is
connected to the Negative (-) terminals on both the
inverter and the 12 volt power source.
5. Connect the cable from the (RED) Positive (+) terminal
on the inverter to the Positive (+) terminal on the power
source.

OPERATION

8