Table of Contents
Advertisement
To connect oscilloscope probes
Attach the probe connector to the desired oscilloscope channel. Push
1
it straight on until it latches into place.
Use Standard BNC Cables
1170 Series Probes are not compatible with Aux Trig In or Aux Out connectors on
Infiniium Oscilloscopes. Use standard BNC cables on these connectors.
Connecting the 1170 Series Probe to the Oscilloscope
Connect the probe to the circuit using any of the probing aids.
2
Connecting the 1170 Series Probe to a Circuit
To disconnect the probe from the oscilloscope, push the small latch on
3
top of the probe connector to the left, then pull the connector body away
from the front panel of the oscilloscope without twisting the probe
connector.
Disconnect Latch on the 1170 Series Probe
1170 Series Low-Mass, Miniature Passive Oscilloscope Probes
To connect oscilloscope probes
11
Advertisement
Table of Contents
