User-Selectable Features - Clifford XL1000 Owner's Manual

User-Selectable Features

Your XL1000 vehicle security system allows you to set many of its features to
your own personal preferences. We have made the programming procedures very
simple: to make a change, you just flick the valet switch a few times.
The system comes from the factory with all of its features pre-programmed as noted
in the table below and on page 7. To change any of the settings, use the procedure
noted. To restore the feature to its factory setting, just repeat the procedure:
1. Select the feature you wish to program from the table on the following
pages. Note the number of flicks and chirps associated with that feature.
2. Insert your ignition key and turn it to the "ON" position.
3. Immediately flick the valet switch back and forth, counting the number of
chirps you hear. Stop when you reach the appropriate number of chirps
4. If noted, do the "secondary action."
5. You will hear one or more chirps (as noted in the "program completion con-
firmation" section) to confirm that you have changed the feature setting.
Turn the ignition off.
6. Repeat steps 1-5 for any other features you wish to program.
Programming Table for User-Selectable Features
# of
Factory
flicks &
Feature setting
chirps
AutoArming 4
ON
AutoArm
5
OFF
& Lock
Arm/Disarm
Chirp Confir- 6
ON
mation
AutoLock/
9
ON
AutoUnLock
Tampering
11
OFF
Warning
FACT —
False Alarm
12
ON
Control and
Test
Program
Secondary
completion
action
confirmation
1 chirp 3
— seconds after
last step
1 chirp 3
— seconds after
last step
1 chirp 3
— seconds after
last step
1 chirp 3
— seconds after
last step
1 chirp 3
— seconds after
last step
1 chirp 3
— seconds after
last step
6
Result
Change state from
ON to OFF or vice-versa
Change state from
ON to OFF or vice-versa
Change state from
ON to OFF or vice-versa
Change state from
ON to OFF or vice-versa
Change state from
OFF to ON or vice-versa
Change state from
OFF to ON or vice-versa
continued . . .