Clifford Matrix 12 Owner's Manual page 46

Clifford owner's guide vehicle security system matrix 12
Hide thumbs Also See for Matrix 12:
Table of Contents

Advertisement

To arm using your remote
You can activate, or arm, the system by pressing
second. When the system arms, you will hear a short siren sound, or chirp, and
the parking lights will flash once. If the vehicle's power door locks have been
connected to the system, the doors will lock.
To disarm using your remote
To disarm the system, press
lights will flash twice. If power locks are connected to the system, the doors will
unlock. If the siren chirps either four or five times when disarming, see
Diagnostics section. This is called Tamper Alert.
Disarming without a transmitter
Turn on the ignition. Press the Valet button the programmed number of times
within 15 seconds. After five seconds, the system will disarm. If it does not, you
may have waited too long. Turn the ignition off and on and try again.
To enter or exit Valet Mode
Turn ignition to RUN position, then turn to OFF position. Press and release
the Valet button within 10 seconds. The status LED will light solid if you are
entering Valet Mode, and it will go out if you are exiting Valet Mode.
To activate Panic Mode
Press and hold
To exit Panic Mode
Press
on the transmitter.
To activate Silent Mode™
Press
will be eliminated for that one operation only.
Location of Valet Button_______________________________
Number of Valet Button pulses for disarming_____________
© 2006 directed electronics
Q Q U U I I C C K K R R E E F F E E R R E E N N C C E E G G U U I I D D E E
down for two seconds.
briefly before arming or disarming, and the confirmation chirp(s)
on your transmitter for one
. You will hear two chirps, and the parking
41

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents