Makita UB401MP Original Instruction Manual page 9

3.
Align the pin with the arrow mark on the
power unit. Insert the pipe until the release but-
ton pops up.
Make sure that the position line is on the tip of
the arrow mark on the power unit, and the arrow
mark on the power unit and the arrow mark on
the pipe are facing each other.
► 1. Release button 2. Arrow mark on the
power unit 3. Pin 4. Position line 5. Arrow
mark on the pipe
4. Turn the lever toward the power unit.
1
► 1. Lever
Make sure that the surface of the lever is parallel
to the pipe.
NOTICE:
Do not tighten the lever without
the attachment pipe inserted. Otherwise
the lever may tighten the entrance of the drive
shaft too much and damage it.
1
2
3
4
5
To remove the pipe, turn the lever toward the
attachment and pull the pipe out while pressing
down the release button.
Fig.12
► 1. Release button 2. Lever 3. Pipe
Installing the flat nozzle or
extension nozzle
Optional accessory
1. Remove the front nozzle by turning it as
shown in the figure.
► 1. Front nozzle
2. Attach the adapter pipe to the attachment,
and then turn it to lock it into place.
1
► 1. Adapter pipe 2. Attachment
9 ENGLISH
1
2
1
3
2