Makita UB401MP Original Instruction Manual page 11

Cleaning the machine
Clean the machine by wiping off dust with a dry
cloth or one dipped in soapy water and wrung
out.
Remove dust or dirt from the suction inlet at the
rear of the attachment.
► 1. Suction inlet
Overall inspection
Check for damaged parts. Ask our authorized
service center to replace them if necessary.
Interval of inspection and maintenance
Operating hour
Whole unit
Drive axle
Power unit
1
Visually inspect for damaged
parts
Supply grease
Refer to the instruction manual of the power unit
Lubricating moving parts
NOTICE:
Follow the instruction of the
frequency and amount of grease supplied.
Otherwise insufficient lubrication may damage
moving parts.
Drive axle:
Apply grease (Makita grease N No.2 or equiva-
lent) every 30 hours of operation.
NOTE: Genuine Makita grease may be pur-
chased from your local Makita dealer.
Storage
When storing the attachment separated from the
power unit, put the cap onto the end of the pipe.
Before
Operation
-
11 ENGLISH
Daily (10 30 hours
hours)
- -
-