Advertisement
Maintenance & Adjustments
General Recommendations
•
Always observe safety rules when performing any
maintenance.
•
The warranty on this lawn mower does not cover items that
have been subjected to operator abuse or negligence. To
receive full value from warranty, operator must maintain
the lawn mower as instructed here.
•
All adjustments should be checked at least once each
season.
•
Periodically check all fasteners and make sure these are
tight.
WARNING:
Always stop the motor and disconnect from the
power source before cleaning, lubricating or performing any
repairs or maintenance on the lawn mower.
Lubrication
1.
Lubricate the wheels at least once a season with light oil (or
motor oil). If wheels are removed for any reason, lubricate
surface of the pivot arm and inner surface of the wheel
with light oil. See Fig. 6-1.
Figure 6-1
2.
Lubricate the torsion spring on the side mulch plug periodically
with light oil to prevent rust. See Fig. 6-1.
Deck Care
WARNING:
To reduce the risk of electric shock, do not expose
the mower to water.
The underside of mower deck should be cleaned after each use
as grass clippings, leaves, dirt and other debris will accumulate.
This accumulation of grass clippings, etc., is undesirable as it will
promote rust and corrosion.
1.
Remove any buildup of grass and leaves on or around the
motor cover (do not use water). Wipe the mower clean with
a dry cloth occasionally.
2.
If debris has built up on the underside of the unit, tilt the
mower forward or on its side and scrape it clean with a
suitable tool.
IMPORTANT:
Do not use a pressure washer or garden
hose to clean your unit. These may cause damage to electric
components, or the electric motor. The use of water will result in
shortened life and reduce serviceability.
Resetting Overload Protection Switch
This mower is equipped with an overload protection switch to
prevent overheating damage to the motor.
If the overload protection switch pops out:
1.
Release the motor/blade control handle and do NOT restart
the mower for at least one minute, allowing the electric
motor time to cool.
2.
Press the overload protection switch inward to reset. See
Fig. 6-2.
Figure 6-2
6
15
Advertisement
