What Each Button/Channel Does - Clifford intelliguard 900-IQ Owner's Manual

To transmit either channel 1, 2, 3 or 4:
instance, to transmit channel 3, press button 3. While you transmit, the LED indicator
will blink once every second: this indicates level 1.
To transmit either channel 5, 6, 7 or 8:
buttons 1-4 to level 2 (channels 5-8). Then press the desired button within the next 7
seconds. For instance, to transmit channel 5, press the LevelShift button once, then
press button 1. While you transmit, you'll notice that the LED indicator blinks twice,
pauses, blinks twice, etc.: this indicates level 2.
To transmit channel 9, 10, 11 or 12:
buttons 1-4 to level 3 (channels 9-12). Then press the corresponding button within the
next 7 seconds. For instance, to transmit channel 10, press the LevelShift button twice,
then press button 2. While you transmit, you'll notice that the LED blinks three times,
pauses, blinks three times, etc.: this indicates level 3.
NOTE: One second after you stop transmitting level 2 or level 3 (channels 5-12), the
remote control automatically returns to level 1 (channels 1-4).

What each button/channel does

Your IntelliGuard 900-IQ remote controls come pre-programmed so that certain
channels command certain functions. If you wish, you can actually assign any channel
except 9 through 12 to any function (see pages 21-25). The following chart indicates what
each remote control channel number does, and how to transmit each channel number.
Factory settings of the 12 remote control channels
Transmitting
channel
number:
1
arm or disarm and lock or unlock the doors
turn on the headlights (if the system is armed)
2
optionally pop the trunk (if the system is disarmed)
3
4
activate optional accessory function #1
5
activate optional accessory function #2
6
activate optional accessory function #3
7
activate optional accessory function #4
8
activate optional accessory function #5
9
remotely enter or exit valet mode (see pages 15 and 16)
10
remotely turn off optional sensor #2 (see page 17)
remotely adjust sensitivity of the OmniSensor's
11
remotely adjust sensitivity of the OmniSensor's
12
Just press either button 1, 2, 3 or 4. For
Press the LevelShift button once. This shifts
Press the LevelShift button twice. This shifts
Causes the system to:
AND
silently arm or disarm
primary zone (see page 17)
warning zone (see page 17)
12
Press the How Press
LevelShift many button
button? times? number
no — 1
no — 2
no — 3
no — 4
yes once 1
yes once 2
yes once 3
yes once 4
yes twice 1
yes twice 2
yes twice 3
yes twice 4