Keyless Entry In Valet Mode; Sensor Adjustment; Remote Controlled Override Of One Or Both Sensor Zones; Autolock And Autounlock - Clifford concept 50x Owner's Manual

Keyless entry in valet mode

Even if valet mode is enabled, you can still remotely control the convenience features.
For instance, press button 1 (channel 1) as if you were disarming: the doors will unlock
(confirmed by one indicator light flash) and the interior lights will turn on. Press
button 1 again and the doors lock (confirmed by two flashes). You can also use the
other channels to activate options such as a remote boot release or remote engine starting.

Sensor adjustment

The two zones of your Concept 50x's Proximity Sensor provides dual-level protection
of your vehicle. If someone is lurking near your car, perhaps bringing their hands and
face to the window to see what is inside, the outer zone of the sensor will pick up this
nearby movement and trigger your Concept 50x to issue its warning tone. But if a thief
actually leans into the passenger compartment, the sensor's interior zone will be
triggered and the system will instantly blast the full alarm sound. The Clifford
Electronics Proximity Sensor is a radar-type sensor that uses a more sophisticated, more
accurate and more reliable technology than that of ultrasonic-type movement sensors.
As such, the Dual-Zone Proximity Sensor of your Concept 50x is impervious to normal
environmental conditions such as wind and temperature variations that cause
ultrasonic sensors to false alarm.
Your Authorised Clifford Dealer will have adjusted each of the two sensor zones at
the time of installation. If you find that the sensitivity setting of one or both appears
to be a bit off the mark, any local Authorised Clifford Dealer will be happy to make
any necessary readjustments without charge.

Remote controlled override of one or both sensor zones

Transmitting channel 10 (two presses of the side LevelShift button, then a press of
button 2) within 10 seconds of arming the system will override the exterior warning
zone of the Dual-Zone Proximity Sensor. When you do so, you will see 4 indicator
light flashes to confirm the zone override. This is useful when parking in an area
with heavy pedestrian traffic. Transmitting channel 10 again within the 10 second
period will override both zones of the sensor for those times when you must leave a
passenger or pet in the vehicle. The sensor zones are automatically restored the next
time you arm the system.

AutoLock and AutoUnLock

For your safety and that of your passengers, the doors automatically lock the instant
you turn on the ignition (see User-selectable features on pages 16-20). When you
turn the ignition off, AutoUnLock automatically unlocks the doors. To suit your
preferences, you may turn off either or both the AutoLock and/or AutoUnLock
features.
12