Front Axle Gear Oil Level Check; Hub Bolt Replacement; Differential Carrier Oil Seal Replacement - Mitsubishi Pajero Pinin 1999 Workshop Manual

MB991618
Flat-tipped screwdriver
Oil seal
FRONT AXLE ±

FRONT AXLE GEAR OIL LEVEL CHECK

Top up the specified gear oil if the gear oil level does not
reach the bottom of the filler plug.
Specified gear oil:
Hypoid gear oil API classification GL-5 or
higher, SAE viscosity No.90, 80W
NOTE
SAE 90 for 10 ° C or higher, SAE80 for 10 ° C or
lower
Capacity:
Front differential: Approx. 0.83
Free-wheeling clutch: 0.12

HUB BOLT REPLACEMENT

MB99 767
1. Rotate the hub to align each hub bolt with the cutout
section of the dust cover, and push out each hub bolt
while locking the hub with the special tool.
2. To press in the hub bolt, install each hub bolt at the
cutout section of the dust cover, and tighten the hub
MB990767 bolt with the hub nut as shown.
DIFFERENTIAL CARRIER OIL SEAL
REPLACEMENT
1. Remove the front housing assembly. (Refer to P.26-26.)
2. Remove the drive shaft <RH>. (Refer to P.26-19.)
3. Use a flat-tipped screwdriver or the like to remove the
oil seal.
On-vehicle Service
26-11