Front Axle Hub Assembly; Removal And Installation - Mitsubishi EVO VIII 260 Service Manual

REMOVAL AND INSTALLATION

CAUTION
!
• Do not strike the ABS rotors installed to the EBJ outer race of drive shaft against other parts when
removing or installing the drive shaft. Otherwise the ABS rotors will be damaged.
• Be careful not to strike the pole piece at the tip of the front ABS sensor with tools during servicing
work.
• During maintenance, take care not to contact the parts or tools to the caliper because the paint of
caliper will be scratched. And if there is brake fluid on the caliper, wipe off quickly.
Pre-installation Operation
• Front Under Cover, Side Under Cover Removal
• Transmission Oil Draining (Refer to
GROUP22A, On-vehicle Service − Manual
Transmission Oil P.22A-149. )
• Transfer Oil Draining (Refer to GROUP22A,
On-vehicle Service −Transfer Oil P.22A-149. )
167 ± 9 N·m
10
108 ± 10 N·m
8
5
Removal steps
1. Split pin
<<A>> >>A<<
2. Drive shaft nut
>>A<<
3. Washer
4. Front ABS sensor
<<B>>
5. Caliper assembly
<<C>>
6. Brake disc
7. Dust cover
FRONT AXLE

FRONT AXLE HUB ASSEMBLY

FRONT AXLE HUB ASSEMBLY
M1261001700483
11
12
108 ± 10 N·m
Post-installation Operation
• Check the dust cover for cracks or damage by
pushing it with your finger.
• Transfer Oil Filling (Refer to GROUP 22A,
On-vehicle Service−Transfer Oil P.22A-149. )
• Transmission Oil Filling (Refer to GROUP22A,
On-vehicle Service − Manual Transmission Oil
P.22A-149).
• Front Under Cover, Side Under Cover
Installation
25 ± 5 N·m
4
9
N
Removal steps (Continued)
8. Connection for lower arm ball joint
<<D>>
9. Self-locking nut (tie rod end
connection)
<<E>>
10. Drive shaft
11. Nut (hub and knuckle to strut
connection)
12. Hub and knuckle assembly
7
6
8.9 ± 1.9 N·m
3
2
226 ± 19 N·m
AC211630
26-7
1
N
AC