Put The Product In Storage Room; Consultation On Typical Faults And Solutions, And Faq; Typical Faults And Solutions - Haier DW-86L338J Service Manual

B

11.3 Put the product in storage room

11.3.1 Difficulty in entering: if the height of the door of the room, which is required by the customer for placing the
freezer is lower than the freezer without pallet, and there is no other way, the method of removing the machine
compartment front shield and opening the outer door by 180° can be considered. Removal of machine compartment
and precautions are as follows.
Note: Generally speaking, it is not recommended to removing the machine compartment front shield.
11.3.2 ① Remove the two screws under the machine compartment front shield.
② Remove the front shield.
Fixing screw for machine compartment front cover
③ Open the outer door by 180°.
After the product enters the door, install the machine compartment front shield as it is.
Note: It must be installed in place, otherwise it will cause safety and performance problems!
Avoid bumping and scratching during handling. During handling, the maximum tilt angle should not exceed
45° (angle with horizontal direction) to avoid refrigeration system fault and affect normal use.
XII. Consultation on typical faults and solutions, and FAQ

12.1 Typical faults and solutions

A. Inconsistency between the display temperature and actually measured temperature of the freezer;
Because the display temperature is the temperature of a certain point in the freezer, the temperature measured by the
user is the temperature of another point in the freezer, and there must be temperature difference between different
positions, besides, there is also a certain error between the user's measuring tool and our temperature sensing probe;
ULT Energy-saving Series After-sales Service Manual
C
Remove the machine compartment front cover
D
44