Samsung AC BNNDCH Series Installation Manual page 33

• 5) SEG20
If you set the Individual control with remote control option to a value other than 0 to 4, it is automatically
set to 0 (Indoor 1)
• 6) SEG21
Default value of Heating setting compensation is 9°F(5 ).
• 7) SEG23
Soft Off: The indoor unit turns off its operation at the indicated time in the table for Installation Option after
its final motion detection. But, it turns on again if the MDS detects motion.
Hard Off: Designated time after SOFT OFF, it cannot turn on automatically when it detects motion. Users
should control to turn on the indoor unit with remote control, etc.
Changing the addresses and options individually
When you want to change the value of a specific option, refer to the following table and follow the steps in
Common steps for setting the addresses and options on page 23.
Option SEG1
Function Page
Indication Details
Indication
and details
0
Example: Changing the Buzzer control (SEG17) option of the installation options to 1 disuse.
Option SEG1
Function Page
Indication 0
CAUTION
• If your indoor units support both cooling and heating, the mixed operation (two or more indoor units operate
in different modes simultaneously) is not available when the indoor units are connected to the same
outdoor unit. If you set an indoor unit as the main indoor unit by using the remote control, the outdoor unit
automatically operated in the current mode of the main indoor unit.
SEG2 SEG3
Option mode to
Mode
change
Indication Details Indication
Option
D
type
SEG2 SEG3
Option mode to
Mode
change
D 2
SEG4
Tens position of the
option number
Details Indication Details Indication
Tens
0 to F position 0 to 9
value
SEG4
Tens position
of the option
number
1
SEG5 SEG6
Units position of
New value
the option number
Details Indication
Units
New
position 0 to 9
value
value
SEG5 SEG6
Units position
of the option New value
number
7 1
Details
0 to F
33
English