Table of Contents
Advertisement
16. Adjust the LINE, EASY and POINT DATA again viewing all
over the screen.
If need the adjustment at the around of screen, select the
"ORIGINAL" and adjust it.
17. To store the data after the Green Convergence Adjustment
has been completed, push the "MAIN MENU" button and
then push the "N" button (pushing the "N" button will store
2
the data in the E
PROM).
18. Remove the Convergence Adjustment Sheet from the
screen.
TX-51P800X / TX-51P800HM / TX-51P800HQ / TX-43P800X / TX-43P800HM / TX-43P800HQ / TX-43P800HZ
10.4.2. Red Convergence Adjustment
1. Push the "MUTE" button twice and change to the Red
Adjustment of Yellow Colour.
2. Repeat the same steps described for the Green Conv.Adj.
in 1~16 to perform the Red Convergence Adjustment.
3. To store the data after the Red Convergence Adjustment
has been completed, push the "MAIN MENU" button and
then the "N" button.
10.4.3. Blue Convergence Adjustment
1. Push the "MUTE" button twice and change to the Blue
Adjustment of cyan Colour.
2. Repeat the same steps described for the Green Conv.Adj.
in 1~16 to perform the Blue Convergence Adjustment.
3. To store the data after the Blue Convergence Adjustment
has been completed, push the "MAIN MENU" button and
then push the "N" button.
4. To switch from the Convergence Adjustment Mode to the
Service Mode, press the Power button and then push the
"N" button.
Repeat the same adjustment after inputting the 60Hz
(NTSC) signal.
41
Advertisement
Table of Contents
