Table of Contents
Advertisement
10.2. Convergence Adjustment Procedure
1. Input a monoscope pattern of PAL.
2. Enter the Service Mode1.
3. Select the Coarse Convergence by pushing "RED" or
"GREEN" buttons. Then push "YELLOW" button, and push
Position and [N] buttons to set the data to zero.
4. Stick the Convergence Adjustment Sheet (PAL 50Hz) onto
the screen.
5. Push the "YELLOW" or "BLUE" on the remote control, and
enter the Coarse Convergence Adjustment mode.
6. Push the "0" of 10 key buttons, and then push the "N" of
position buttons on the remote control.
7. Enter to "TEST POS." mode.
8. Push the "5" button to display the monoscope pattern on
the screen.
9. Adjust the position buttons so that the cursor in the center
of the test pattern is aligned with the center of the
monoscope pattern.
TX-51P800X / TX-51P800HM / TX-51P800HQ / TX-43P800X / TX-43P800HM / TX-43P800HQ / TX-43P800HZ
10. Push the "TV/AV" button on the remote control, and enter
the "DATA POS." mode.
11. Push the "5" button and close the background image
(monoscope pattern).
12. Use the "+" and "-" of the position buttons so that the bump
in the screen center line is at the center of the cursor.
13. Push the "TV/AV" button twice, and enter the "OSD POS"
mode.
14. Adjust the position buttons so that the cross-cursor is
aligned near cross-bar.
15. Push the "SET UP" button, and "N" button to store data.
16. Push the "0" of 10 key buttons, and return to Coarse
Convergence Adjustment mode.
33
Advertisement
Table of Contents
