Table of Contents
Advertisement
7. Release CRT anode lead from CRT chassis wire clamp and
all other wires from holders.
8. Wire the anode lead wire.
9. Lift out CRT assembly with lens assembly and other CRT
neck assemblies.
10. Lay CRT face down on a soft cloth.
11. Remove CRT lens by removing (4) screws.
12. Install yoke and VM coil with other CRT neck assemblies on
CRT neck in the same order and position as removed from
the defective CRT.
13. Push yoke against bell of CRT and tighten the clamp just
snug enough so it will not easily shift.
14. Assemble CRT focus lens assembly to new CRT with (4)
screws. Make sure focus lens adjustment nut is in the same
location as on other CRT focus lens.
Note:
Please assemble with screws in the order shown in detail
and tighten with same torque.
TX-51P800X / TX-51P800HM / TX-51P800HQ / TX-43P800X / TX-43P800HM / TX-43P800HQ / TX-43P800HZ
11
Advertisement
Table of Contents
