Table of Contents
Advertisement
CPE DS1 (G.703) C
Do one of the following:
•
Connect the XMT and RCV interfaces to the appropriate wire wrap pins of each
connecter. To determine slot and pin assignments, refer to the documentation for the
product being installed.
•
Connect the XMT and RCV interfaces to P1 and P2 connectors.
•
Purchase optional 12-port RJ48 harmonic cable assemblies from ADC for the CPE
interface : RJ48C (Part Number 150-2201-01) or RJ48X (Part Number 150-2201-02).
You can attach these cable assemblies to the top, bottom, or either of the two side
panels through the wall mounting holes located on each panel.
locations of these mounting holes on the side panel.
RJ-48C/X
Slot 1
Slot 12
Figure 5. Twelve-Port, Harmonic Cable DS1 Interface Assemblies
T
-U
URN
Before handling plug-in modules, attach a wrist strap to the
antistatic jack on the front of the enclosure (lower left-hand
side).
1
Open the front panel of the enclosure by loosening the Hex nut at the top, then lower
the panel.
2
Insert the card in its assigned slot. Refer to the card's user manual for complete
information.
P5
1
Slot 1
2
4
5
RCV
Slot 12
Slot 1
XMT
1
2
4
Slot 12
5
P
ONNECTIONS
P1
15
R
1
Slot 1
5
T
26
12
15
R
Slot 12
37
5
T
P2
49
R
1
Slot 1
55
T
26
49
R
12
Slot 12
55
37
T
Figure 1
shows the
H0332-A
Advertisement
Table of Contents
