Appendix B: Command List - Xilinx Zynq UltraScale+ RFSoC ZCU208 User Manual

Command List
The commands supported by the evaluation tool are classified as basic commands, RFDC IP
commands, board control commands, and PL data and control commands. The following table
lists the supported commands.
Table 3: Command List
Command
GUI_Title
RfdcVersion
Version
TermMode
GetLog
JtagIdcode
Help
Disconnect
GetBlockStatus
GetCalFreeze
GetCalibrationMode
UG1433 (v1.2) October 27, 2021
RF Data Converter Evaluation Tool User Guide
Input Parameters
None Rftool Version
None Version Number(s)
None Rftool Version
Mode None
None Logged Strings
None Idcode
None None
None None
Type, Tile, Block, BlockStatus.SamplingFreq,
BlockStatus.AnalogDataPathStatus, BlockStatus.DigitalDataPathStatus,
Type, Tile, Block
BlockStatus.DataPathClocksStatus, BlockStatus.IsFIFOFlagsAsserted,
BlockStatus.IsFIFOFlagsEnabled
Tile, Block, CalFreezePtr.CalFrozen, CalFreezePtr.FreezeCalibration,
Tile, Block
CalFreezePtr.DisableFreezePin
Tile, Block Tile, Block, CalibrationMode
Output Parameters
Basic Commands
RFDC IP Commands
Send Feedback

Appendix B: Command List

Appendix B
Description
Rftool version, for
example, (RFEvalTool
v1.8).
RFdc API version.
Rftool version.
Switch between UI
mode (mode=0) and
Interactive mode
(mode=1). Interactive
mode prints more
status information to
the terminal and
should not be used
with the evaluation
tool GUI.
Uses metal_log to
return any error,
warning, or
informational
messages returned
from the API or
command interface.
Return the device
JTAG IDCODE.
Print help on
command interface.
Cf. PG269
Cf. PG269
Cf. PG269
www.xilinx.com
27