Installation; Preparing For Intellectual Stack - Dukane 9007WU User Manual

2. Installation

For safety reasons, read 1.1 Basic information and preparations ( 3, 4 ) carefully
before installation. In addition, take note of the followings for proper use of Instant
Stack.
●
Use the same model projectors.
● Arrange the projectors side by side.
● Make sure the projection screen is
perpendicular to the projectors.
● Project images larger than the recommended
screen size shown in the table. The greater
the distance between the projectors, the
larger the screen size needs to be.
L: distance [cm] Recommended screen size [inch]
50
75
100
● To avoid incorrect operations with the remote control, it is recommended to operate
with the control panel or a wired remote control if you control one projector with the
remote control during installation. KEYLOCK or REMOTE ID function is also available.
(Operating Guide → OPTION menu)
● Images from Set A and Set B may superimpose well but the image positions can shift
over time. Readjust to superimpose the images.

2.1 Preparing for Intellectual Stack

When using Intellectual Stack via RS-232C connection, ensure the following settings are
set on the two projectors. Otherwise, the Intellectual Stack menu cannot be operated.
● STANDBY MODE in SETUP menu: NORMAL
(Operating Guide → SETUP menu)
● COMMUNICATION TYPE under COMMUNICATION in SERVICE menu: OFF
(Operating Guide → OPTION menu)
● STACK LOCK in SECURITY menu: OFF
When STACK LOCK is set to on, menus related to Instant Stack cannot be operated. It is
therefore necessary to set it to off during installation and menu setting.
(1) Use the ▲/▼/◄/► buttons to go into the following menu.
ADVANCED MENU > SECURITY (> ENTER PASSWORD) > STACK LOCK
STACK LOCK dialog will appear on screen. (Operating Guide
→ SECURITY menu)
(2) Use the ▲/▼ buttons to highlight OFF, and press the ► button
to complete the setting.
270
330
390
5
Screen
size
Projector
0 ± 10cm
L (50cm or more)