Parallel Interface Connection; Serial Interface Connection - Kyocera Mita Ecosys FS-1800 Installation Manual

Parallel Interface Connection

Clip
Parallel Printer Cable

Serial Interface Connection

Serial Interface Cable
8
Clip
1
Plug one end of the printer cable (not
included) into the parallel interface con-
nector on the rear of the printer.
• Use a parallel printer cable
that complies with the
IEEE1284 standards.
• The printer will work best if it
is installed near the computer.
The connecting cable should
be shielded and not be longer
than 3 meters (10 feet).
2
Close the clips on both sides to fix the
connector in place.
Plug the other end of the printer cable
into the computer's parallel interface
connector.
1
Plug one end of the printer cable (not
included) into the serial interface con-
nector on the rear of the printer.
The printer will work best if it is
installed near the computer. The
connecting cable should be
shielded and not be longer than
3 meters (10 feet).
2
Securely tighten the screws on both
sides of the connector.
Plug the other end of the printer cable
into the computer's serial interface con-
nector.