Kyocera Ai3030 Connection Manual page 20

4. Select Setup TCP/IP in the Protocols column and change the settings
as appropriate. If unsure of the correct Subnet mask, and the first
number in the NIC's IP address is from 192 to 254, then use
255.255.255.0 as the Subnet mask. The Base Port Number displayed is
one less than the printer's actual port number, this for the default of
9100, the Base Port Number is set to 9099. Host-based lpd requires a
port number of 10001, therefore, if using host-based lpd, change the
Base Port Number to 10000.
5. Type the sysadm password in the appropriate box and click Accept
Settings. After a few seconds, the screen should report that the
update was successful. Click the Back Arrow icon twice to return to
the NIC Configuration page.
6. Optional: Click on Configure Status Page in the Printer column to
define power-up status page settings, (e.g., disabling the power-up
status page).
7. The changes made to the NIC do not take effect until the unit is reset.
Click on Reset in the System column and click Reset Unit. After a
few seconds the screen should report
TCP/IP configuration is now complete.
that the unit was reset.
20