Table of Contents
Advertisement
After setting the NIC's IP parameters, connect to the NIC with the
browser by typing http://<IP address>, (e.g., http://192.42.211.5). At the
NIC Home Page, click on NIC Configuration and follow the MAP config-
uration instructions (beginning with step 3) in the NetWare 4.x Directory
Services Configuration section in this guide (the settings other than Net-
Ware Print Server Name do not need to be entered).
IPX Protocol Installation
The IPX Protocol is required for peer-to-peer printing. IPX is not installed
by default when Windows 95/98 is first installed, but it can be easily
added by using the following procedure.
1. Click on the Windows 95/98 Start button and select Settings, Control
Panel, Network.
2. Check to see if IPX/SPX-compatible protocol is displayed on the list
of network components. If it is on the list, IPX is already installed.
Please continue with the next section. If it is NOT on the list, click on
Add.
3. Double click on Protocol, click on Microsoft, and double click on IPX/
SPX-compatible Protocol. Windows 95/98 will prompt for the
required Windows disks to install the IPX protocol.
4. Once the files are copied, click on OK to close the network control
panel. Windows 95/98 will prompt to restart the system. The IPX
protocol will not be active until the system is restarted.
Peer-to-Peer Printing Software Installation
The peer-to-peer printing software should be installed on each Windows
95/98 or Windows NT 4.0 PC that will use peer to peer printing services.
1. Install and Run the Peer-to-Peer Software.
• Insert the disk included.
• Click on the Windows 95/98 Start button and select Run.
• For IPX: Type <Drive>:\IPX-P2P\SETUP.EXE and click OK.
• For IP: Type <Drive>:\IP-P2P\SETUP.EXE and click OK.
11
Advertisement
Table of Contents
